The cantilever can be single-sided or double-sided. The cantilever rack has the characteristics of stable structure, good load capacity and high space utilization. Loading and unloading of goods is carried out by forklifts, trucks or manually.
The height of the cantilever rack is usually within 2.0 meters (if the goods are accessed by a forklift, it can be as high as 6 meters), the length of the cantilever is within 1.5 meters, and the load of each arm is usually within 800KG.
Cantilever racks are mostly used in machinery manufacturing industries and building materials supermarkets. After adding shelves, it is especially suitable for warehouses with small space and low height. It is easy to manage, has a wide field of vision, and has a higher utilization rate than ordinary shelves.
The base of the cantilever rack can be made of h-shaped steel or special profiles. The H-beam steel is selected according to the load-bearing requirements and the national standard steel is selected accordingly. Open the bolt connection eye on the h-beam to facilitate the connection with the column. The bottom is welded and connected to the bottom plate, and the expansion bolt eyes are opened on the top of the bottom plate, so that the shelf can be connected to the ground with expansion bolts. to fix the shelf.
The cantilever rack uses special profiles as the base, and welds two pieces of c-shaped steel back to back with connecting steel plates, and the width of the connecting steel plates is the width of the column. After the two pieces of c-shaped steel are welded, the connecting bolt eyes are opened at the position of the connecting column to facilitate the connection with the column. The bottom plate is welded to the side, which is convenient for the expansion bolt to connect with the ground.
The cantilever rack column is butt-welded with two pieces of c-shaped steel. The c-section steel is made of q235 high-quality strip steel. After being rolled into c-section steel by the rolling mill line, the cantilever connection control is punched out on the automatic punching machine, and the hole spacing is 140mm. A connecting steel plate will be welded under the column if it is connected with h-beam. If the connection with the special profile is adopted, the bolt connection hole will be opened at the connection part under the column.